Sears 758.14808 - Manual (Page 9)

Troubleshootìhg
TROUBLE ^ PROBABLE CAUSE REMEDY
1. Unit will not run,
or will hot shut off.
• Switch Actuator (Ffoat) not
free to work properly.
• Remove shipping rubber
band or unhook switch
actuator ring. (Rgure 7).
2. Water runs out of
hole in the water
level label on the
front of the unit.
• Too much water. • Check FULL label in tank. Do
not overfill.
3. Unit will not dry
out completely.
• Switch actuator ring is not in
place.
• High humidity or low
temperature resulting in slow
evaporation.
• Connect switch actuator ring.
See instructions (page 7,
Rgure 7).
•Allow unit to continue running
until reservoir becomes dry.
4. Unit will not cycle
(Turn off) when
out of water.
• Roat Is hung up, or holder
is not on the filter tracks.
• Check float (page 7, Figure
9).
• Remove filter holder, install
on filter tracks (page 8,
Figure 10).
5. Filter does not
float.
• Roat may have leak.
• Cardboard packing piece
between motor support and
filter holder.
•Check float for leak, replace if
necessary.
•Remove cardboard.
CAUTION
Use only 32-14900 EPA Registered Bacteriostat available from SEARS Retail store.
Use of other water treatment products may damage the filter elements.
Under no circumstances should you use water treatment products designed for
Roto belt or Ultrasonic humidifiers.