Important, Step2, Operating humidifier controls – Sears 758.14808 User Manual
Page 5: Humidity control, Air flow control, Warning, Fill light
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
WARNING
To avoid fire or shock hazard, do not
pour or spill water into control or
motor area, if coitrois get wet, let
them dry comptewly apd have unit
checked by authorized service per
sonnel before plugging It In.
IMPORTANT
Be sure water does not go above FULl¿
mark or water will overflow from the
hole located in the water level indica
tor label.
Step2
Carefully pour water into humidifier. (Pour
water at left of the controls as shown in
Figure 4.)
I^^tarik with clean water up to FULL indi
cator label, located inside the housing on
the
rear panel (Figure
4).
NOTE: Do not overfill humidifier. Water
will overflow from the.overflll hole if
capacity is exceeded.
OVERFILL
HOLE
Figure 4
Operating Humidifier Controls
Humidity Control:
Adjust the amount of humidity depending
on user's needs. The humidifier will turn
on cuid crff as required to makttain level of
humidity
you
select.
(See
Figure
5.)
MEDIUM
setting
is
recommended
but
there are times when low or high amount
of humidity may be preferred. For con
stant operation of humidifier, CONSTANT
ON allows for the maximum amount of
humidity to be evaporated into the air
continuously.
IMPORTANT
Water damage may result if condensa
tion starts to form on windows or
walls. Humidify Control setting should
be
lowered
until
condensation
no
longer forms.
Air Flow Control:
The higher the air flow speed, the more
water is evaporated and released Into the
air. LOW ¿peecLis the quietest and is pro
vided for conditions that may not require
as high an evaporation rate. (See Figure
5.)
,
Fill Light:
When unit has a small amount of water
left in it, a orange fill light will come on and
unit will shut off. (See Figure 5.)
QUET
8
comrm*
OAUON
ñ i n i L O V . -
Figure 5