Sears 536.884811 - Manual (Page 9)

ASSEMBLY
TO INSTALL THE SHIFTER LEVER
® Stand the snow thrower up on the front of the auger
housing, as shown in Figure 6.
® Cut the plastic tie which holds the shifter lever as­
sembly to the shift bracket.
® Remove the locknut, washer, spring and the bolt.
Reposition the shifter lever into the slot in the control
panel, as shown in Figure 6 and reinstall the bolt,
spring washer and the locknut.
® Tighten the locknut until 1 /8” to 3/16" (2 or 3 threads)
of the bolt protrude past the locknut
® Thread the shifter lever knob onto the threaded end
of the shifter lever until it is tight.
® Move the shifter lever through all the speeds to en­
sure proper tension of the spring, If the shifter lever
sticks in any of the notches, loosen the locknui 1/4
turn at a time until the shifter lever moves freely.
TO CHECK/ADJUST CLUTCH
CONTROL CABLES
The control cables attached to the auger clutch lever and
traction clutch lever may need to be adjusted before you
use your snow thrower.
For instructions on checking or adjusting the clutch
control cables, see To Adjust The Clutch Control Cables
paragraph on page 18.