Sears 153.33645 - Manual (Page 19)

Operating Instructions (cont’d)
Temperature Regulation
Due to the nature of the typical gas water heater, the water tem­
perature in certain situations may vary up to 30“F higher or
lower at the point of use such as, bathtubs, showers, sink, etc.
This means that when the temperature adjustment dial is set at
the mark approximating 120“ F, the actual water temperature at
any hot water tap could be as high as 150“F or as low as 90°F.
Any water heaters intended purpose is to heat water. Hot water
is needed for cleaning (bodies, dishes, clothing). Hot water will
present a scald hazard. Depending on the time element, and the
people involved (normal adults, children, toddlers, elderly,
infirm, etc.) scalding may occur at different temperatures.
A WARNING
HOTTER WATER CAN SCALD: Water heaters are intended to
produce hot water. Water heated to a temperature which will
satisfy clothes washing, dish washing, and other sanitizing needs
can scald and permanently injure you upon contact. Some peo­
ple are more likely to he permanently injured by hot water than
others. These include the eideriy, children, the in^rm, or physic^-
ly/mentally handicapped. If anyone using hot water in your home
fits into one of these groups or if there is a local code or state law
requiring a certain temperature water at the hot water t^, then
you must take special precautions. In addition to using the lowest
possible temperature setting that satisfies your hot water needs,
a means such as a mixing valve, should be used at the hot water
taps used by these people or at the water heater. Mixing valves
are available at plumbing supply or hardware stores. Follow man­
ufacturers instructions for installation of the valves. Before
changing the factory setting on the thermostat, read the
“Temperature Regulation” section in this manual.
AWARNING
Never allow small children to use a hot water tap, or to draw
their own bath water. Never leave a child or handicapped per­
son unattended in a bathtub or shower.
The thermostat of this water heater has been factory set at its
lowest position, to reduce the risk of scald injury. It is adjustable
and must be reset to the desired temperature setting. The mark
(V) HOT indicative of approximately 120“F is the preferred
starting point. Some states have a requirement for a lower set­
ring, If you need hotter water, follow directions for temperature
adjustment, but beware of the warnings in this section.
Turn the water temperature dial clockwisej/'^ to decrease
the temperature, or counterclockwise
{/' to increase the
temperature.
VHOT — Is a thermostat setting of approximately 120°F,
which will supply hot water at the most econom­
ical temperatures. The temperature adjustment
knob can be turned lower than “HOT” if
desired.
A — Is a thermostat setting of approximately 130°F.
B - Is a thermostat setting of approximately 140“F.
This is the lowest setting for supply of hot water
to dishwashers.
C - Is a thermostat setting of approximately 150°F,
VERY HOT - Is a thermostat setting of 160“F. It is recommend­
ed that the dial be set lower whenever possible.
AWARNING
Should overheating occur or the gas supply fail to shut off,
turn “OFF” the manual gas control valve to the appliance.
19