Installation checklist, Installation instructions (cont’d) – Sears 153.33645 User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Installation Instructions (cont’d)
Installation Checklist
BEFORE LIGHTING THE PILOT;
• Check the gas lines for leaks.
a. Use a soapy water solution. DO NOT test for gas leaks
using a match or open flame.
b. Brush the soapy water solution on all gas pipes, joints and
fittings.
c. Check for bubbling soap. This means you have a leak.
Turn “OFF” gas and make the necessary repairs.
d. Recheck for leaks.
e. Rinse off soapy solution and wipe dry.
» Is the new teinperature-pressure relief valve properly installed
and piped to an adequate drain? See “Temperature-Pressure
Relief Valve” section.
* Are the cold and hot water lines connected to the water
heater correctly? See “Water Piping” instructions in the
“Installation Instructions” section,
• Is the water heater completely filled with water? See “Filling”
instructions in the “Installation Instructions” section.
» Will a water leak damage anything? See the “Facts to
Consider About the Location” section.
♦ Is there proper clearance between the water heater and any
thing that might catch fire? See the “Facts to Consider About
the Location” section,
» Do you have adequate ventilation so that the water heater
will operate properly? See “Combustion Air and Ventilation”
in the “Installation Instructions’ section.
* Is the draft hood vent piping properly secured? See “Venting”
instructions in the “Installation Instructions” .section.
* Is there proper clearance between the vent pipe and anything
that might catch on fire? Sec “Venting” instructions in the
“lastallarion Instructions” section,
» Is the vent pipe properly sloped and docs the vent terminate
outdoors? See “Venting” instructions in the “Installation
Instructions” section.
» Do you need to call your gas company to check the gas pipe
and its hookup?” section.
VENT PJPl TO
OUTDOORS
OR CHIMNEY
SHUTOFF VALVE
COLO
GAS SUPPLY
TEMPERATURE-
PRESSURE
RELIEF VALVE
DISCHARGE PIPE
(Do not cap or plug)
SHUTOFF VALVE
TEE
DRIP LEG
(Sediment trap)
CAP-
DRAIN VALVE
WATER HEATER
GAS BTU/HR. QAL,rHR,
MAWiihjM HyCfflOSTATiC QAS PRESSURE IN W.G.
WOfWNfl 3A«r, INLET MIfi, iMtêt PSESaURE MiWJ8R3ti3
150
MODEL RATING PLATE
16