Sears 919.15516 - Manual (Page 11)

PARTS LIST
KEY KEY
NO. PART NUMBER DESCRIPTION NO. PART NUMBER DESCRIPTION
1 SGE-4039-180 Air Cap/Retaining Ring • 20 STD583031 Retaining Ring
(Suction Feed) • 21 STD302008 0 Ring
2 AV-601-EX Fluid Tip (Suction Feed) 22 JGA-4003 Adjusting Screw Assy.
• 3 AV-1 Gasket 23 JGS-449 Air Valve Assembly
4 JGA-1225 Baffle (incl. Key #24-29 & 14)
• 5 23165-001 0-Ring 24 JGA-14 Snap Ring
6 JGA-51 Lock Nut 25 JGA-15 Washer
7 P-JGA-2-2 Nipple • 26 JGS-26 U Cup Seal
• 8 JGA-7 Packing 27 JGK-10 Valve Body
9 34411-122 Packing Nut • 28 JGS-431 Air Valve Assembly
• 10 JGA-35 Trigger Bearing Stud • 29 MBD-12 Spring
11 JGA-108 Trigger 30 SGE-48 Swivel Nut
• 12 A-42 Screw 31 SGE-47 Adapter
13 SGE-37 Nipple 32 SGE-27 Yoke
• 14 JGS-72 Gasket (2 used) 33 SGE-15 Cam
15 JGA-17 Bushing 34 SGE-45 Gasket
16 JGA-402-DEX Fluid Needle 35 SGE-405 Lid/Tube Assembly
• 17 MBD-19 Spring 36 SGE-403 Cup Assembly
18 JGS-16 Adjusting Screw 37 JGS-143-1 Valve Body
19 JGA-4004 Fan Adjustment Assembly
(incl. Key # 20-22 & 37) 38 SGE-410 Gun Body
1 9-15968 Repair Kit This kit contains ali the 0-rings, gaskets, and packing parts necessary to
keep your spray gun in top working condition, (includes Key Nos. 3, 5, 8,
10, 12, 14, 17, 20, 21, 26, 28 & 29.)
OPTIONAL ACCESSORIES
The following parts may be ordered from your Sears Service Center to add to the versatility of your gun.
PART NO. DESCRIPTION USES
SGE-439-158 Air Cap & Retaining This is an external mix, suction feed air cap assembly which is ideal for small
Ring Assembly painting jobs such as lawn and garden equipment and auto repair and touch
up. Air usage is lower (requires 6.4 SCFM @ 40 PSI) than the air cap
assembly supplied on your gun. This air cap assembly is used with the fluid
tip and needle supplied on the gun.
KK-4474 Conversion Kit This kit contains an air cap, retaining ring, fluid tip and fluid needle which are
the optimum combination for painting with a paint tank (pressure feed). This
kit will help you control your paint flow better. It is especially good for spray­
ing thinned lacquers on large jobs, such as auto refinishing. It also works well
with heavier bodied paints like primer and latex. Air requirements are 12.4
SCFM @ 40 PSI.
NOTE; YOU SHOULD NEVER USE COMBINATIONS OTHER THAN STATED IN ABOVE CHART OR AS PROVIDED
STANDARD ON YOUR GUN. YOU MAY NOT GET GOOD PERFORMANCE WITH OTHER COMBINATIONS.
11