Sears 139.53535SRT1 - Manual (Page 16)

installatiori Step 4
Position the Opener
Follow instructions which apply to your door
type as illustrated.
CAUTION
To prevent damage to steel, aluminum,
fiberglass or glass panel doors, do not rest the
opener on the door without using a 2x4.
S.EÇT10NAL.:P&or:^&: ONE-PIECE ^Door::wfth Track
A 2x4 laid fiat is convenient for setting an ideal
door-to-T-rail distance.
• Raise the opener onto a stepiadder.
You will need help at this point if the ladder is
not tall enough.
• Open the door ail the way and place a 2x4 laid flat
on the top section beneath the T-rail.
If the top panel hits the trolley when you raise
the door, pull down on the trolley release arm to
disconnect the inner and outer sections. The
trolley can remain disconnected until Step 12 is
completed.
:ÔNE#iЛ€Й'.Door:without^Track:
With the door fully open and parallel to the floor,
measure the distance from the floor to the top of
the door.
Using a stepiadder as a support, raise the opener
to the same distance as the door from the floor (it
will be at a slight angle as shown).
The top of the door should be level with the top of
the opener. Do not position the opener more than
2" above this point.
16