beautypg.com

Sears 139.53859 User Manual

Owner's manua, Warning

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

Model 139.53879

3-Function Remote Control

To comply wish FGC rulas, apjtisiman!

ot

modiFiralíons ol ihis receiver antHor

transmitter era prohítíHed, except lor changing the code ssiting or replacing the
battery THERE ABE NO OTHER USER SERVICEABLE PARTS

The 53000 Series remote control works only with
door openers and light controls having a green

“SRT" button and green indicator fight

instructions are given below for programming your
opener to match the remote control's code. The
additional remote control buttons can also activate

other garage door openers and/or light controls.
(Instructions for programming light products are
Included with those accessories.)

Program the Opener to Accept

the Remote Control Code

Select a remote control push button to operate the
receiver. The large button is recommended for use with
the garage door opener,

1 Press and HOLD the selected remote control push

button, Figure 1,

2- Then press and release the green "SRT" button on the

right side panel of the opener in Figure 2„ The opener

light win flash once.

3 Release the remote control push button

Now the opener will operate when the remote control
push button is pressed.

If you release the remote control push button before
the opener light flashes, the opener has not
accepted the code.

To Change the Selected Push Button

On the Same Remote Control

If you decide to use a different remote control button

than originally programmed into the opener, you need to
erase a//the learned codes and reprogram each remote
control used to operate the garage door opener.

To Erase Aif Remote Control Codes

° Press and hold the green “SRT" button on the opener

pane! unis! the indicator light turns off (about 6
seconds). A//the codes the opener has learned will
be erased,

• To reprogram, repeat Steps 1 - 3 for each remote

control in use.

Code programming instructions are also located on
the opener panel.

Replacement Parts:

3-Function remote corviroi housing

only

(no circuit board) - 41A4B73;

Compact remofe control housing only (no circuit board) - 41A4874;
3V 2016 Lithium Battery • 10A19 (2 taquired); Visor Clip - 29S134

Owner's Manua!

Model 139.53859

Compact 3-Function Remote Controi

A

WARNING

Children operating or playing with a garage door

opener can injure themselves or others.

The

garage door could close and cause serious Injury
or death.

Do not allow children to operate the

door push button(s) or remote control(s).

A moving garage door could injure or kill

someone under It

Activate the opener only when

you can see the door clearly, It is free of
obstructions, and is properly adjusted.

FIGURE 1

Select a remote control posh

53000 Series Garage Door Openers

(With Green "SRT" Button and Green Indicator Light)

FIGURE 2

Green 'SRr

Button

Green Indicator

Ughi

^WARNING

Keep batteries away from small children. If
swallowed, promptly notify doctor.

3-FUNCTlON

Open lilts end

first to avoid

cracking

housing

The Remote Control Batteries

The lithium batteries should
produce power for up to 5 years.

Replace batteries positive side
down, as follows.

3-Function remote: Use the

visor clip or screwdriver
blade to pry open the case

as shown To replace the cover, insert the 3 tabs at the
opposite end and snap shut.

Compact remote: Use a screwdriver blade to pry open
the case as shown. To replace cover, snap shut along

both sides

114A1959

1

1995. Sears Roebuck & Company

All Rights Reserved

Printed in Mexico

Table of contents