Sears 631.29739 - Manual (Page 5)

ASSEMBLY
Assembly requires two people. Set the treadmill In a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly Is completed. Refer to the ^Irawlngs below to identify the small
parts used in assembly. Assembly requires the included alien wrench | and your own phillips screw-
(jrjver
,
adjustable wrench wrench and scissors
1. With the help of a second person, carefully lay the
treadmill on its right side as shown (refer to the drawing
on page 4 to identify the right side).
Insert the Extension Legs (41) into the treadmill. Make
sure that the Extension Legs are turned so the Base Pads
(36) are on the indicated side. Attach each Extension Leg
with an Extension Leg Screw (34).
With the help of a second person, carefully raise the
treadmill to the upright position so the Extension Legs
(41) are resting flat on the floor.
Refer to the inset drawing. Remove the nut, bolt, and
shipping bracket from the left Upright (14).
2. Refer to HOW TO LOWER THE TREADMILL FOR USE
on page 11. Follow the instructions in step 2 to lower the
treadmill.
Position the Left Handrail (2) on the left Upright (14) as
shown. Thread a Handrail Bolt (15) with a Handrail
Washer (16) into the left Upright and the Left Handrail. Do
not tighten the Handrail Bolt yet.
Attach the lower end of the Left Handrail (2) to the
Extension Leg (41) with a 3 1/2” Handrail Bolt (89), a 3/8”
Washer (99), and a Flange Nut (57). Do not tighten the
Handrail Bolt yet.