Sears Vacuum Cleaner - Manual (Page 8)

VSÊNG AUACHMENTS
TO USE AHACHMENTS
A WARNING
Personal Injury Hazard
DO NOT place hands or feet underneath the unit
when inserting the hose. The brush assembly begins
to revolve rapidly when the vacuum Is fumed on and
is switched to a carpet height setting.
Place the cleaner on a flat surface, put the handle In
the upright position and move the height adjustment
to HIGH.
The attachments will fit on the hose or the wand. In
addition the dusting brush wili aiso fit on the crevice
tooi.
The hose and wand can be pulied off the short hose
by grasping the cuff twisting and puiiing up.
A
CAUTION
DO NOT pull the vacuum cleaner around the room
by the hose. Property domeñe could result.
The attachments can be added to the hose if the
item to be cleaned is not far from the cleaner. The
hose will expand.
NOTE: When cleaner is turned on the hose will have a
tendency to collapse due to suction of the cleaner.
If more reach is needed the wand can be attached
to the hose and the attachments can be added to
the wand.
A
CAUTION
When using attachments, be careful not to over­
extend the hose length when reaching. Trying to
reach beyond the hose reach could cause the
cleaner to tip over.
ON SOME MODELS:
An extra wand, without tabs, is included. This extra
wand can be added to the wand with tabs for extra
reach. Insert wand and twist a quarter of a turn to
secure fit.
If the dusting brush is being used and more distance
is needed the crevice tool can be added to the
wand and the dusting brush can be added to the
crevice tool.
Dusting Brush Crevice Tool Wartd
TO STORE AHACHMENTS
Return the hose and wand to its position on the short
hose and the attachments to their holders.
A
CAUTION
Attachments used in dirty areas (under a
refrigerator) should not be used on other surfaces
until they are washed. They could leave marks.
AUACHMENT USE CHART
ATTACHMENT
Furniture*
Between
Cushions* Drapes* Stairs Walis
CREVICE TOOL
X X X X X
LJc~z
—^
DUSTING BRUSH X X X X
‘Always clean
attachments
before using
on fabrics.