Sears Vacuum Cleaner - Manual (Page 15)

mHT BULB CHANGING
NOT ON ALL MODELS
A WARNING
Elecfrical Shock Or Personal Injury Hazard
Disconnect electrical supply before servicing or
cleaning the unit. Failure to do so could result In
electrical shock or personal Injury from cleaner
suddenly starting.
Disconnect electrical supply.
The handle must be pulled down and the cleaner
turned over.
Release the lower plate by pushing the tabs in
toward the center.
Grasp the clips at the back and pull forward and up
to remove the lower plate.
With the lower plate off the bulb housing can be
pulled off the flange it is mounted to by wiggling the
socket back and forth.
With the bulb housing loose the bulb can be
removed by pushing in and twisting it counterclock­
wise. The new bulb can be placed in the socket, line
up the post on the bulb with the slots in the socket
and while pushing the bulb into the socket, twist the
bulb clockwise.
(NOTE: See page 3 for Bulb #.) <
A
CAUTION
Replace the light bulb with the same or smaller
wattage size to prevent damage to surrounding
parts.
A
CAUTION
Do not plug In or turn on until completely
reassembled.
Reinsert the bulb housing onto the flange by pushing .
down.
Reinstall the lower plate by placing the front tabs on
the plate into the slots on the nozzle housing and
pushing the plate to the rear until the back clips snap
into place. Push the tabs to the outside.
14