Installation step 9, Warning, Electrical requirements – Sears CRAFTSMAN 139.53640SRT User Manual
Page 20
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Installation Step 9
Electrical Requirements
To reduce the risk of electric shock, your garage
door opener has a grounding type plug with a third
grounding pin. This plug will
only f\t
into a grounding
type outlet.
If the plug doesn’t fit into the outlet you have,
contact a qualified electrician to install the proper
outlet.
To avoid installation difficulties,
do not run the opener at this time.
To prevent electrocution or fire, instailation
and wiring must be in compiiance with locai
eiectricai and building codes.
Do NOT use an extension cord, 2-wire adapter,
or change the plug in any way to make it fit
your outlet.
Wrong
If permanent wiring is required by your local code, refer to the following procedure:
A
WARNING
To prevent electrocution, remove power from
the garage door opener and from the circuit
you plan to use for the permanent connection.
To make a permanent connection through the
7/8" diameter hole in the top of the opener
(according to local code):
• Remove the opener cover screws and set the
cover aside.
• Remove the attached 3-prong cord.
• Connect the black (line) wire to the screw on the
brass terminal; the white (neutral) wire to the
screw on the silver terminal; and the ground wire
to the green ground screw.
The opener must be
grounded.
• Reinstall the cover.
To avoid installation difficulties,
do not run the opener at this time.
20