Program the timer, Set water hardness number, Note – Sears 625.34842 User Manual

Page 39: Set recharge (regeneration) time, Water softener start-up 1c. program the timer

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SECTION 1

WATER SOFTENER START-UP

1C.

PROGRAM THE TIMER

2. SET WATER HARDNESS NUMBER:

■ Press the SELECT button once to display 15
(flashing) and HARDNESS.

HARDNESS

The grains per gallon (gpg) hard
ness of your water supply is on
your water analysis report. Be sure
to enter water test results on page
2, for future reference.

NOTE:

If your water supply contains iron, compensate for it
by adding to the water hardness number. Aor

example, assume your water is 15 gpg hard and
contains 2ppm iron. Add 5 to the hardness number

for each 1 ppm of iron. In this example, you would

use 25 for your hardness number.

2 ppm iron

5 = 10

(times)

15 gpg hardness

+10

25 HARDNESS NUMBER

■ Press the 0 UP/DOWN 0 buttons to set your
water hardness number in the display. The DOWN
button moves the display to 1. The UP button moves

the display to the highest setting (see maximum
setting for your model in the specifications).

NOTE:

Each press of the UP/DOWN button changes the
display by 1 between 1 and 25. Between 25 and the
highest number, the display changes 5 at a time.. .25,
30, 35, etc. Continuous pressure on the UP or DOWN
button changes the display twice each second.

3. SET RECHARGE (REGENERATION) TIME:

■ Press the SELECT button once to display 2:00 AM
(flashing) and RECHARGE TIME.

RECHARGE

TIME

At the 2:00 AM RECHARGE TIME

setting, the softener begins regen
eration (see pages 11 and 12) at
2:00 AM, ending no later than 4:00

AM. This is a good time in most
households because water is not

being used (see AUTOMATIC BY
PASS, page 13).

If a different RECHARGE TIME setting would be
better for your household, do the following.

■ Press the 0 UP/DOWN 0 buttons to set the
desired RECHARGE starting hour. Be sure to observe

the AM-PM as you did when setting the time of day.

NOTE:

Each press of the UP/DOWN buttons changes the
display 1 hour. Continuous pressure on the UP or
DOWN button changes the display twice each
second.

■ Press the SELECT button once again, to return

the present time (steady) of day and RECHARGE
TONIGHT in the display.

3- <3

RECHARGE TONIGHT

IF YOU NEED HELP PROGRAMMING THE TIMER, CALL TOLL FREE, NUMBER 1-800- 426- 9345.

SEE PAGE 10 FOR OTHER FACE PLATE TIMER FEATURES.