To replace headlight bulb, Interlocks and relays, To replace fuse – Sears 917.25254 User Manual

Page 24: To remove hood and grill assembly (see fig. 28), Service and adjustments

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SERVICE AND ADJUSTMENTS

TO REPLACE HEADLIGHT BULB

» Raise hood,

•

Pull bulb holder out of the hole in the backside of the

grill.

» Replace bulb in holder and push bulb holder securely

back into the hole in the backside of the grill.

» Close hood.

INTERLOCKS AND RELAYS

Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent it from starting.

» Check wiring. See electrical wiring diagram in the

Repair Parts section of this manual.

TO REPLACE FUSE

Replace with 30 amp automotive-type plug-in fuse. The

fuse holder is located behind the dash.

TO REMOVE HOOD AND GRILL ASSEMBLY

(See Fig. 28)

•

Raise hood.

•

Unsnap headlight wire connector.

■> Stand in fr ont of tractor. Grasp hood at sides, tilt toward

engine and lift off of tractor.

■» To replace, reverse above procedures.