To adjust steering wheel alignment, Front wheel toe-in/camber, To remove wheel for repairs (see fig. 26) – Sears 917.25254 User Manual

Page 23: To start engine with a weak battery (see fig. 27), Service and adjustivients

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SERVICE AND ADJUSTIVIENTS

TO ADJUST STEERING WHEEL ALIGNMENT

If steering wheel crossbars are not horizontal (left to right)

when wheelsare positioned straightforward, remove steer

ing wheel and reassemble per instructions in the Assembly
section of this manual,

FRONT WHEEL TOE-IN/CAMBER

The front wheel toe-in and camber are not adjustable on

your tractor. If damage has occurred to affect the front
wheel toe-in or camber, contact your nearest authorized
service center/department.

TO REMOVE WHEEL FOR REPAIRS

(See Fig. 26)

» Block up axle securely,

» Remove axle cover, retaining ring and washers to allow

wheel removal (rear wheel contains a square key - Do

not lose),

“ Repair tire and reassemble.

•

On rear wheels only: align grooves in rear wheel hub
and axle. Insert square key.

" Replace washers and snap retaining ring securely in

axle groove.

•

Replace axle cover.

TO START ENGINE WITH A WEAK BATTERY

(See Fig. 27)

CAUTION: Lead-acid batteries gener

ate explosive gases. Keep sparks, flame
and smoking materials away from bat
teries. Always wear eye protection
when around batteries.

If your battery is too weak to start the engine, it should be
recharged. If “jumper cables" are used for emergency
starting, follow this procedure:

IMPORTANT: YOUR TRACTOR IS EQUIPPED WITH A 12
VOLT NEGATIVE GROUNDED SYSTEM. THE OTHER
VEHICLE MUST ALSO BE A 12 VOLT NEGATIVE
GROUNDED SYSTEM. DO NOT USE YOUR TRACTOR
BATTERY TO START OTHER VEHICLES,

TO ATTACH JUMPER CABLES -

■■ Connect each end of the RED cable to the POSITIVE

(+) terminal of each battery, taking care not to short

against chassis.

Connect one end of the BLACK cable to the NEGA
TIVE {-) terminal of fully charged battery,

“ Connect the other end of the BLACK cable to good

CHASSIS GROUND, away from fuel tank and battery.

TO REMOVE CABLES, REVERSE ORDER -

■> BLACK cable first from chassis and then from the fully

charged battery.

» RED cable last from both batteries.

POSITIVE TERMINAL

______\

NEGATIVE TERMINAL

z__

CHASSIS

POSITIVE

TERMINAL

CABLES

CHARGED

■ BATTERY

NEGATIVE

TERMINAL

FIG. 27