Sears PRO-FORM 831.24733.0 - Manual (Page 9)

7. Set the Console Assembly (91) face down on a
soft surface to avoid scratching the Console
Assembly. Hold the Right Handrail (33), which
has a large hole in one side, near the Console.
Next, insert the console wire and the tie into the
hole in the side of the Right Handrail (33). Using
needlenose pliers, pull the console wire out of
the hole near the bracket on the Right Handrail.
Then, set the Right Handrail (33) on the Console
Assembly (91). Make sure that no wires are
pinched. Start an M5 x 16mm Screw (85) with a
M5 Star Washer (7) into the Right Handrail, and
then start two M4.2 x 19mm Screws (10) into the
Right Handrail. Tighten the M5 x 16mm Screw
and then tighten the two M4.2 x 19mm
Screws; do not overtighten the Screws.
Attach the Left Handrail (not shown) to the
Console Assembly (91) in the same way. Note:
There are no wires on the left side.
8. Remove the plastic ties from the Right Handrail
(33) and the Left Handrail (not shown). With the
help of a second person, hold the Console
Assembly (91) near the Right Upright (54).
Remove the wire tie from the Wire Harness (39).
Connect the Wire Harness to the console wire.
See the inset drawing. The connectors
should slide together easily and snap into
place. If they do not, turn one connector and try
again. IF THE CONNECTORS ARE NOT CON­
NECTED PROPERLY, THE CONSOLE MAY
BE DAMAGED WHEN THE POWER IS
TURNED ON. Insert the connectors and the ex­
cess wire downward into the Right Upright (54).
9. Attach the Console Assembly (91) to the Right
Upright (54) and the Left Upright (53) with four
M8
X 15mm Bolts (8) and four M8 Star Washers
(5). Make sure that no wires are pinched. Start
all four Bolts but do not tighten them yet.