Sears PRO-FORM 831.24733.0 - Manual (Page 14)

HOW TO TURN ON THE POWER 3. start the walking belt.
IMPORTANT: If the treadmill has been exposed to
cold temperatures, allow it to warm to room tem­
perature before turning on the power. If you do not
do this, the console displays or other electrical
components may become damaged.
Plug in the power cord (see
page 12). Next, locate the
reset/off circuit breaker on
the treadmill frame near the
power cord. Switch the cir­
cuit breaker to the reset po­
sition.
IMPORTANT: The console features a display demo
mode, designed to be used if the treadmill is dis­
played in a store. If the displays light as soon as
you plug in the power cord and switch the circuit
breaker to the reset position, the demo mode is
turned on. To turn off the demo mode, hold down
the Stop button for a few seconds. If the displays
remain lit, see THE INFORMATION MODE on page
17 to turn
off the demo mode.
Next, stand on the foot rails of the treadmill. Find the
clip attached to the key (see the drawing on page 13)
and slide the clip onto the waistband of your clothes.
Then, insert the key into the console. After a moment,
the displays will light. IMPORTANT: In an emergency
situation, the key can be pulled from the console,
causing the walking belt to slow to a stop. Test the
clip by carefully taking a few steps backward; if the
key is not pulled from the console, adjust the posi­
tion of the clip.
HOW TO USE THE MANUAL MODE
1. Insert the key into the console.
See HOW TO TURN ON THE POWER on page
13.
2. Select the manual mode.
When the key is in­
serted, the manual
mode will be selected. If
you have selected a
speed workout, reselect
the manual mode by
pressing the Workouts button repeatedly until only
zeros appear in the displays.
GOD
aOCDw.l QD=
To start the walking belt, press the Start button, the
Speed increase button, or one of the numbered
speed buttons.
If you press the Start button or the Speed increase
button, the walking belt will begin to move at 1 mph.
As you exercise, change the speed of the walking
belt as desired by pressing the Speed increase
and decrease buttons. Each time you press a but­
ton, the speed setting will change by 0.1 mph; if
you hold down a button, the speed setting will
change in increments of 0.5 mph. Note: After you
press the buttons, it may take a moment for the walk­
ing belt to reach the selected speed setting.
If one of the numbered speed buttons is pressed,
the walking belt will gradually change speed until it
reaches the selected speed setting.
To stop the walking belt, press the Stop button.
The time will begin to flash in one of the displays.
To restart the walking belt, press the Start button or
the Speed increase button.
4. Change the incline of the treadmill as desired.
10
To change the incline of
the treadmill, press the
Incline increase and de­
crease buttons. Each
time you press one of the
buttons, the incline will
gradually increase or decrease until it reaches the
selected incline setting.
5. Follow your progress with the track and the dis­
plays.
The track—The track
represents a distance of
1/4 mile (400 meters). As
you walk or run on the
treadmill,
the indicators
around the track will ap­
pear in succession until the entire track appears.
The track will then disappear and the indicators will
again begin to appear in succession.
14