Sears 917.25953 - Manual (Page 25)

SERVICE AND ADJUSTMENTS
TO REPLACE HEADLIGHT BULB
• Raise hood,
« Pull bulb holder out of the hole In the backside of the
grill.
• Replace bulb In holder and push bulb holder securely
back into the hole in the backside of the griti.
• Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause your tractor to run
poorly, stop running, or prevent It from starting.
• Check wiring. See electrical wiring diagram In the
Repair Parts section of this manual,,
TO REPLACE FUSE
Replace with 30 amp automofivedype plug-in fuse. The
fuse holder is located behind the dash.
TO REMOVE HOOD AND GRILL ASSEMBLY
(See Fig. 32)
• Raise hood,
• Unsnap headlight wire connector,
• Stand in front of tractor. Grasp hood at sides, tiittoward
engine and lift off of tractor,
• To replace, reverse above procedures.
ENGINE
TO ADJUST THROTTLE CONTROL CABLE
(See Fig. 33)
The throttie control has been preset at the factory and
adjustment should not be necessary. Check adjustment as
described below before loosening cable. If adjustment is
necessary, proceed as foilows:
• With engine not running, move throttle control lever
from stow (■^) to choke (|\|) position. Siowiy move
lever from choke (i\|) to fast {%) position,
» Check that holes "A” ingovernorcontrolieverandhole
in governor piate line-up. if holes "A” are not afigned,
loosen clamp screw and move throttle cable until holes
are aligned. Tighten clamp screw securely,
25