Sears 911.91768 - Manual (Page 3)

!MPORTANT INSTRUCTIONS FOR YOUR SAFETY
SAVE THBSBINSTRUCTIONS
Bead alt instructions before using this appliance. When using
gas or electrical apUanceSf basic safety precautions should be
followedf including the following.
V
STABILITY DEVICE
WARNING
• AH Ranges Can Tip
• Injury To Persons Could
Result
• Install Anti-tip Device
Packed With Range
• See Installation Instructions
i
il
Tools you will need:
Phillips head screwdriver
1 3/8' open end or adjustable wrench
INSTALLATION OF THE
ANTI-TIP DEVICE
f. Remove the bracket from the prepack
located inside the oven.
2.
3 ,
Decide whetherthe bracket will be installed
on the right or left side of range location.
If the bracket side of the range is adjacent
to a cabinet, place the bracket against
back wall and cabinet as shown below.
If there is no adjacent cabinet, determine
where the location of the range side (painted
outside panel) will be. Place the bracket
with its outside edge at this location and
against back wall. See illustration below.
4, Determine whether you will anchor the
bracket to the fioor or wall. Make sure this
location is clear of electrical wiring or
plumbing.
5, Fasten the bracket securely with the screws
provided. Sere ws are self-drilling in wood,
plywood, particle and chip board, and
most
metal framing. If attaching to
masonry, you can buy suitable screws and
anchors at hardware stores. Useamasonry
drill to drill the required holes.
BRACKET
WALL
PLATE
SCREW MUST ENTER
WOOD OR METAL
6.
7 .
ATTACHMENT TO WALL
Using the wrench, back out the four leg
levelers at least two turns. See your
installation
guide for more leveling
information before positioning range.
Slide the range into place. Be sure rear leg
le veler fully engages the slot in the bracket. If
range cannot be moved back far enough
for rear leg leveler to enter bracket, move
bracket forward as required and attach to
floor In new location.