Sears 831.29723 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

6, SYMPTOM: THE WALKING BELT IS OFF-CENTER OR SUPS

a. If the waltdng belt has shifted to the lefL fi^t remove the safety

key and UNPLUG THE POWER CORD. Using the alien wrench,

turn the left rear rotter adjustment bolt clockwise, and the right

bolt counterclockwise, 1/4 of a turn each. Be careful not to over
tighten the walking belt Plug in the power cord, insert the safety
key and run the treadmill for a few minutes. Repeat until the belt

is centered.

b. If the walking belt has shifted to the right, first remove the safety

key and UNPLUG THE POWER CORD. Using the alien wrench,
turn the left rear roller adjustment bolt counterclockwise, and the

right bolt clockwise, 1/4 of a turn each. Be careful not to over

tighten the walking belt. Plug In the power cord, insert the safety
key and run the treadmill for a few minutes. Repeat until the belt
is centered.

c. If the walking belt slips when walked on, first remove the safety

key and UNPLUG THE POWER CORD. Using the alien wrench,
turn both rear roller adjustment bolts clockwise, 1/4 of a turn:
When the walking belt is correctly tightened, you should be able

to lift each side of the walking belt 2-3 inches off the walking plat
form. The center of the walking belt should just touch the walking
platform. Be careful to keep the walking belt centered. Plug in the

power cord, insert the safety key and run the treadmill for a few
minutes. Repeat until the walking belt is properly tightened.

7. SYMPTOM: IT IS DIFFICULT TO INSERT OR REMOVE THE LOCK PIN

a. It may be necessary to twist each upper body arm slightly in order to align the holes that the lock pin goes

through. Do not twist the upper body arms too far or you may damage the treadmill.

STORAGE

Before converting the CROSS WALK to the stowaway position,

turn the Resistance Control (15) counterclockwise until the

Control turns freely.

Unplug the power cord. Remove the Lock Knob (77) and Lock Knob

Washer (78) from the Upright (10). Lay the Upright and the Left and

Right Upper Body Arms (1,2) on the walking belt. Keep the Lock
Knob and Washer in a secure location.