Positioning flange, 1 " screws, 1/2" screws – Sears FTK-130 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
FTK-127/130 Built-In Trim Kit Installation Instructions
For yse with the following microwave oven ACM2160A and UMC5200AA
Installing Unit in Cytoyt
1. Slide microwave oven into cutout verifying alignment of
unit is correct.
2. Slide unit out to plug the power cord into the outlet.
3. Slide unit into cutout centering the microwave oven in
the cutout opening. Verify anti-tip bracket is engaged.
Bottom duct
4.
5.
Ensure the microwave oven is accurately centered
after verifying the anti-tip bracket is engaged.
Using a Ve4i drill bit drill pilot holes through the
positioning flange into wood or metal framing and
secure with V
2
" screws in the bottom duct.
Positioning flange
Mounting Trim Frame
1. Position trim frame over the microwave oven.
2. Verify trim frame is level and the microwave oven is
centered within the trim frame.
NOTE: Center the trim frame equally on all four sides.
3. Mark center positions screw holes (one in each corner)
through the mounting holes of the trim frame.
Remove trim frame and drill previously marked pilot
holes using a Visi drill bit.
4.
■ 1 " screws ^
1 " screws
■ ^1
5. Attach trim frame to wood or metal frame work using 1'
screws (supplied).
Trim kit is completed
•
Replace any loose items that were removed from the
inside of the microwave.
•
Retain installation instructions for future reference.
1/2" screws
26-7/8"
Trim Frame Dimensions
Depth of the trim frame is Vs".
19-1/8"
29-3/4"
19-1/8"
Part NO.8101P555-60
Part NO.3828W5U0295