Sears FTK-130 - Manual (Page 3)

FTK-127/130 Built-In Trim Kit Installation Instructions
For use with the following microwave oven ACM2160A and UIVIC5200AA
Installation of Bottom Bracket
1. Disconnect power from microwave oven before
proceeding with installation.
2. Remove any loose items from inside the microwave
oven.
3. Fasten bottom bracket to bottom duct using V 2 " screws
(supplied).
4. Turn microwave upside down and place on a protected
surface.
Upper
duct
Tabs
Side
duct
3.
4.
5.
Remove any oil or dirt on the surface of the microwave
oven where ductwork will be secured.
Peel off the protected backing on the double sided
tape.
Place the existing screw through the ductwork and
start securing the screw DO NOT TIGHTEN. Slowly
push the ductwork towards the microwave keeping
proper alignment of the ductwork. Press down firmly to
secure the ductwork and tighten the screw securely.
Preparing for Anti-Tip Bracket
1. Fold or cut the edges from the template along the
guide lines.
2. Race the template along the front edge of the cutout
floor, centering the template from sidentonside.
3. Mark the hole positions of the antintip bracket.
4. Remove the template and drill two holes for antintip
bracket. Use a drill bit no larger than TaJ to make
holes.
5. Attach bottom duct to bottom of microwave using
'Ai screws (supplied).
6. Turn microwave oven and bracket right side up, placing
it on a protected surface.
Instaliatlon of Vented Ductwork
1. Remove screw located on left side of microwave below
vent louvers.
2. Secure side duct to upper duct, by inserting metal tabs
on upper duct into slots on side duct and bending tabs
upward as indicated in the foliowing illustration.
Place antintip bracket onto the cutout floor and secure
using V
2 " screws.
1/2" screws
Anti-tip bracket