Hoover 56518114 - Manual (Page 5)

Press cord into cord clip on back of
handle- Pull cord light and wrap cord
around hooks (A2).
S t o r i n g h o s e & t o o l s
Store hose on holder by first positioning
hose In front section of clip.
Continue wrapping hose under iower
hook (F) , Snap hose end fully into hold­
er (G).
Ensure that the hose end is pushed
down completely into bolder (G),
Slide crevice too! (H) into holder (some
models only).
Position stalr/upholstery nozzie in holder
at base of cloanor and snap it into placo
as shown at arrow.
insert end of bare floor attachment
{soma models only) into holder and snap
into clip as shown.
P o w e r e d h a n d t o o l
The powered hand too! is shipped in a
plastic bag for protection. Remove the
bag before using the tool by first open­
ing tool door.
To remove powered hand tool (1). puli it
down and outward.
To reposition the tool, reverse this piroce-
dure,
To remove the scrub moduki’^ (J), grasp
It at the sides and pull it forward,
To rc?positlon module, fit tabs in the stor­
age area into holes on back of module,
Push module to snap it securely into
position.
'^'included with some models, storage on
LS model only
H o w t o r e a t t a c h t o o l
c o v e r
Th e tool cover Is designed with a break­
away feature which allows it to snap free
if it is pushed open too far.
To reattach, align hinges of cover with
holes on sides of tool storage area.