Hoover 56518114 - Manual (Page 12)

After using scrub tool
To clean scrub pad, puM it off module,
Wash it in water with mild detorgont,
Rinse and let air dry.
Pad must btî compiniely dry before rcîOT-
tachlng to module and storing on deep
cleaner.
Roplaaement pads may also be pur­
chased. Ask for HOOVER pari no,
40308001.
To store scub module, remove scrub
module from tool In same manner as
removing the brush module.
Align openings on back of module with
tabs in storages area (G),
Push module into position.
A f t e r u s i n g t o o l
1. Follow steps a and b for 'After clean­
ing" on page 9,
2. Rinse tool and hose by fliling sink
with a small amount of water. Turn
deep cleaner ON and pickup the water
with the toot.
3. Dra in hose by turning deep clea.ner
ON and holding end of hose up for sev­
eral seconds, Do not press trigger.
4. Disconnect deep cleaner from electri­
cal outlet.
5. Drain solution tube (located inside
hose) by pointing end of hose in sink
and pressing trigger,
6. Proceed with steps c. d, and e, for
'After cleaning ' on page 9.
C l e a n i n g c a r p e t e d
s t a 1 r s
Read “Before you begin cleaning”
instructions on page 9.
1, Place handle in upright position.
Agitator brushes will not rotate while
handle is in upright position.
2, Fill clean solution tank with FIOOVER
Carpjot/Upholstery Detergent according
to instructions for Figs. 2-8 to 2-1 4.
3, Attach tool to end of hose,
4, Hose length may rcjquiro that machine
be placed at the top of the stairs to
clean upper half of stairway and at bot­
tom of stairs to clean lower half.
To prevent machine from falling, use
extra caution when cleaning on stairs.
Do not place deep cleaner on stairs.
Do not point tools toward people or
pets.
5, Dry hands and plug deep cleaner into
a property grounded outlet.
6, Turn deep cleaner ON. If necessary,
refer to "Before using tool" section to
remove air from the system,
7, Pre -spray the carpeted stair by hold­
ing the tool (A) or (B) about one inch
above the carpel and push it forward
while pressing the trigger (equals one
wet stroke),
8. Position tool against the riser and sliglitly
press ft into carpet pile. Press the trigger and
pull the tool SiCMfly over tlie carpet (second
wet stroke). Release trigger at end of stroke.
9. Lift tool, and position !t against riser.
Pull tool slowly over carpet without
pressing trigger (dry stroke),
It IS best to altern.ate wet and dry strokes
as described above. End with more dry
strokes to aid in foster drying of carpet.
1 0. Overlap strokes by 112 inch to hc3ip
prevent streaking,
To avoid saturating carpet, do not use
more than 4 wet strokes over any one
area. Always end with dry strokes.
If additional cloaning is necessary wait
until the carpet is completely dry before
using the tool again,
11. Empty recovery tank when th €2 motor
sound becomes higher pitched and
thoro ¡5 a loss in suction (see ’Automatic
shut-off", Fig, 2-6).
When finished cleaning, follow "After
cleaning” instructions on pagn 9 and
"After using tool” instructions on page 12.
1 2