Hoover 56518114 - Manual (Page 14)

Press both latches (B) and pul! brush
block out. The brushes can be cleaned
under rurtning water.
T o r e p l a c e b r u s h e s
Align posts (C) on both ends of brush
assembly with slots (D) in cleaner hous­
ing,
Make sure that the square post (E) also
aligns with the square hole (F). Turn
brushes slightly until post fits easily into
hole,
S t c ; o r a g e
Before storing!
• Empty solution tank and rinse
thoroughly with clean water.
• Replace empty solution tank and
turn deep cleaner ON, Squeeze
trigger and push deep cleaner for­
ward and back several times to
oxpfil any solution remaining in the
deep cleaners system. (Do not use
deep cle.snor on wood floors.)
• Empty recovery tank and rinse
thoroughly with clean water,
Allow brushes and underside of deep
cleaner to air dry thoroughly before
storing deep cleaner on a carpeted or
wood surface-
Do not store deep cleaner with a full
solution tank in place.
L u b r i c a t i o n
The motor is t;qulpped with bearings
Which contain sufficient lubrication for
the life of the motor. The addition of
lubricant could cause damage. Do not
add lubricanl to motor bearings.
14
4 . I f y o u h a v e a
p r o b l e m
If a minor problem occurs, it usually con
be solved quite easily when the cause is
found by using the check list below.
Problem: Machine won’t run
Possible cause
Possible solution
• Not firmly plugged in
• Plug unit in firmly
No voltage in wall plug
• Check fuse or breaker
• Blown fuse/tripped breaker
• Replace fuse/reset breaker
Problem: Low suction
Possible cause
Possible solution
- Recovery tank full/automatrc
shut off engaged
• Remove and csmpty recovery tank
> Blockage in tool on end of hose
• Remove tool and clear blockage
• Recovery tank lid not on
correctly
• Make sure lid Is on securely
Problem: Clean solution won’t
dispense
Possible cause
Possible solution
• Solution tank not firmly in place
• Make sure tank is securely locked in
position
• Soluhon tank empty
• Refill tank according to Instructions for
surface being cloanod
• Recovery tank lid not on
correctly
• Make sure lid is firmly in piar.n
• Pump needs to be “primed”|when
using tool)
• See Before using toof^ section, p.11
Problem: Bmshes won’t rotate during
floor cleaning
Possible cause
Possible solution
• Dirty filter screen on bottom of unit
• Clean scf Gon as shown in Fig. 3-2
• Speed selector on OFF
• Move spofid selector to Low or Hi