beautypg.com

Error indicators – Citizen Systems CD-S500A User Manual

Page 41

background image

41

• There are no RS232C communication error or front cover opened/closed detection

indicators.

• If the buzzer setting is OFF in Soft SW Setting Mode, the buzzer does not sound.

: Lit,

: Off

When this printer malfunctions or jams etc., the type of problem is indicated by a buzzer
and by lit or flashing LED on the operating panel.
In error status, the error indication can be cancelled by pressing the FEED switch.

Error indicator table

Error Indicators

Maint

enance Mode

Paper end

POWER

Lit

PAPER OUT

Lit

ERROR

Off

Paper near end

POWER

Lit

PAPER OUT
ERROR

Off

Rear/front cover
open

POWER

Lit

PAPER OUT Depends on status
ERROR

Lit

Head hot

POWER

Lit

PAPER OUT Depends on status
ERROR

HP abnormal

POWER
PAPER OUT
ERROR

Black mark
abnormal

POWER
PAPER OUT
ERROR

Cutter abnormal
position detection

POWER
PAPER OUT
ERROR

Hardware abnormal
RAM read-write

POWER

Off

PAPER OUT
ERROR

Hardware abnormal
FROM read-write

POWER

Off

PAPER OUT
ERROR

24V abnormal

POWER

Off

PAPER OUT

Off

ERROR

Type of Error

LED indicator

Operation and restoration method

During printing, printing stops and the printer goes
offline. Replace the paper and close the cover to
return the printer online.

During printing, printing is immediately stopped and
the printer goes offline. Close the cover to restore the
printer to online status.

In centro-interface, when the Paper Near-End on the
Soft SW is set as enabled, PE, FAULT are output and
printing continues. When it is set as disabled, nothing
is output and printing continues.

Cooling starts. After the temperature has fallen, it is
automatically restored and printing restarts.
The buzzer continues to sound until the error is
cancelled by the FEED switch.

The printer goes offline. Remove the paper jam or
other problem and press the FEED switch to restore
the printer to online status.
The buzzer continues to sound until the error is
cancelled by the FEED switch.

Turn off the power then turn it on again. If the error
continues, notify the dealer where you purchased the
printer or service personnel after turning off the power.