Citizen Systems CD-S500A - Manual (Page 36)

36
Chapter4 Maintenance Mode
Press Feed
Change PARM.
Press Feed For 2S
Next Item
F.Cover Open/Close
Save & Exit
--------------------
Command Type –EPSON
Number of Col. –40/33
Font Select –7 × 9
Paper Plies –OFF
Paper End –ENB
Paper Near-End –ENB
Slashed Zero –OFF
Print Direct. –BI-DIR
Auto LF –OFF
Code Page –437
Buffer Size –4K
Init Signal –ENB
Buzzer –ON
------------------------
Baud Rate –9600
Data Length –8bit
Parity Bit –NONE
Stop Bit –1bit
Protocol –DTR
--------------------
Paper Width –76.2
Auto-Cutter –PAR.
Color Ribbon –ON
Take-Up Device –ON
Black Mark –DIS
Command Type –EPSON
Command Type –STAR
Number of Col. –40/33
Font Select –7 × 9
Font Select –9 × 9
Operations
Press the
FEED Switch
Press and
hold the FEED
Switch
Press and
hold the FEED
Switch
Press the
FEED Switch
Soft SW Setting Mode
Operating method
Press the FEED switch (less than 2 seconds):
The setting changes.
The present set value is changed and the
same item is reprinted. (Press the FEED
switch, and when the buzzer sounds once,
release it.)
Pressing the FEED switch continuously (2
seconds or more):
Moves to the next item.
It prints the present set value of the next
item. (Press the FEED switch, and when the
buzzer sounds three times, release it.)
Opening/closing the front cover:
After saving the set values, it reprints all
items from the top and returns to normal
power on status.
* If the power is turned off without opening
and closing the front cover, the setting
change is invalid.
* If the paper runs out during the change,
set the paper and close the rear cover to
continue the process.
Example of a change of the Command Type to
STAR and the Font Select to 9
Ч9.