Cisco 1-PORT G.SHDSL 2600 - Manual (Page 15)

1-Port G.SHDSL WAN Interface Card for Cisco 2600 Series Routers
dsl equipment-type
15
Cisco IOS Release 12.2(4)XL
dsl equipment-type
To configure the DSL ATM interface to function as central office equipment or customer premises
equipment, use the dsl equipment-type command in ATM interface mode. To restore the default
equipment type, use the no form of this command.
dsl equipment-type {co | cp }
no dsl equipment-type
Syntax Description
Defaults The DSL ATM interface functions as customer premises equipment.
Command Modes ATM interface.
Command History
Usage Guidelines This configuration command applies to a specific ATM interface. You must specify the ATM interface
before you enter this command.
The ATM interface must be in the shutdown state before you enter this command.
Examples The following example shows how to configure DSL ATM interface 1/1 to function as central office
equipment.
Router# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Router(config)# interface atm 1/1
Router(config-if)# dsl equipment-type co
Router(config-if)# end
Router# clear interface atm 0/1
Router#
co Configures the DSL ATM interface to function as central office equipment.
cpe Configures the DSL ATM interface to function as customer premises
equipment.
Release Modification
12.2(4)XL This command was integrated into Cisco IOS Release 12.2(4)XL on the
G.SHDSL WIC on the Cisco 2600 series routers.