Philips AZ241517 - Manual (Page 7)

SPEAKERS OPERATION
REMOVABLE SPEAKERS
Attaching the speakers
• Slide the speakers down into the sleeves on the sides of the
set cabinet. The speakers will click into position.
Taking off the speakers
• Keep the lever (found on the back corner of the speaker)
pressed and slide the speaker upwards.
Connecting the speakers
/. Connect the right speaker to the terminal R, with the red
marked wire to (+) and the black wire to (-).
2. Clip the exposed portion of wire into the corresponding colour
terminal.
3. Repeat the wiring procedure for the left speaker to terminal L,
making sure that you connect the red marked wire to + and
the black wire to -.
Positioning the speakers
The ideal position is obtained when the 2 front speakers and the
listening position build an equilateral triangle and the speakers
are at ear-height.
JVofe: - Speakers with an impedance of 8 ohms or higher other
than as supplied may be used instead. Do not, however,
use speakers with a lower impedance as this will result
in damage to your set.
- When headphones are connected to the headphone
socket ÍT the speakers are disconnected.
GENERAL OPERATION
1. To switch on the set, press the POWER button.
2. To select your sound source press the CD - TAPE - TUNER
button until the desired mode is shown in the display.
3. Adjust the volume using the VOLUME A, T buttons.
-* Display indication shows the level, 0-32 and VOL.
4. Adjust the sound effect by pressing the DSC button once or
more.
-* DBB, JAZZ or POP lights up when activated.
5. Create an enhanced surround sound by pressing the
INCREDIBLE SURROUND button.
-*The INCREDIBLE SURROUND button lights up when
activated.
6. To switch off the set, always press POWER so that the sound
and volume indicators do not remain lit after use.