Philips AZ1020-17 - Manual (Page 9)

CD PLAYER CASSEHE RECORDER
PROGRAMMING TRACK NUMBERS
Programme in the STOP position and store your CD tracks in any
desired sequence If you like, store any track more than once. Up to
20 tracks can be stored in the memory.
— When the programme memor\' is full, ¡'Hi i appears in the
display and it will not be possible to add further tracks.
1. Use the SEARCH !■« or ►►! to select your desired track number.
2. Press PROG
The display shows program and the track number; P.- o 3
appears briefly.
3. Repeat steps 1 and 2 to select and store all desired tracks.
4. Press PLAY* PAUSE ►!! to start playback of your programme.
Reviewing your programme
• To review your set programme, keep PROG pressed for a few
seconds.
— The display will show in sequence all your stored track
numbers.
Erasing a programme
You can erase the contents of the memory by:
- pressing STOP ■ twice;
- opening the CD door;
- moving the CD TUNER TAPE/Off slider.
CASSETTE RECORDER
PLAYING A CASSETTE
1. Adjust the CD TUNER TAPE/orf slider to TAPE/ off position.
2 Press STOP» OPEN *4 to open the cassette holder.
3. Insert a cassette and close the cassette holder.
4. Press PLAY ◄ to start playback.
5. To interrupt playback press PAUSE II. To resume, press the key
again.
6. By pressing ■« or ►►, fast winding of the tape is possible in
both directions.
To stop fast winding, press STOP» OPEN B4
7. To stop the tape, press ST0P»0PEN H4
— The keys are automatically released at the end of the tape,
except if PAUSE II has been activated.
8. To switch off the set make sure the cassette keys are released.