Philips AZ1020-17 - Manual (Page 7)

DIGITAL TUNER CD PLAYER
PROGRAMMING RADIO STATIONS
7. Tune to your desired station, following steps 1-3 under 'Tuning
to radio stations'.
— If the frequency is already stored in the memory, the preset
number will be displayed.
2. Press PROG to activate programming.
— PROGRAM flashes in the display,
3. Press the PRESET control (up or down) to allocate a preset
station number from 1 to 29
4. Press PROG again to confirm the setting.
5. Repeat steps 1-4 to store all other presets.
• You can clear a preset number by storing another frequency in
Its place
To deactivate programming mode
If during programming you decide not to programme a station,
adjust the CD TUNER TAPE/off slider to CD or TAPE/Off position
Tuning to preset stations
Press the PRESET ▼, A control (down, up) until the desired number
IS shown.
O)
s
LU
DISPLAY INDICATION FOR CD FUNCTIONS
C d GPS'.-,: when the CD door is opened
-
Total track number and playing time: in stop mode.
r.o d! 5c. w'hen no disc is inserted.
C d !:>- r . error in CD operation or with the CD
(see 'Troubleshooting'),
-
Current track number and elapsed playing time:
during CD playback.
-
Elapsed playing time freezes and flashes:
in PAUSE position.
- shuffle / repeat ( all ) modes: when the respective mode is
activated.
program : programme mode is active
prog : appears briefly and the selected track number (1-20) when
you programme.
Pit I i : programme memory full.
- when you cancel a CD programme; you press PROG for more
than two seconds but no track has been selected.
- when you press PROG for less than two seconds but no
track has been selected.
n o
d Idi
r J ^
L LI Err
I or QO
I / J