Philips AZ1020-17 - Manual (Page 5)

POWER SUPPLY OPERATION
BAnERlES
For the set (optional)
• Open the battery compartment and insert six batteries, type
R20, UM1 or D-cells (preferably alkaline) with the correct
polarity as indicated by the (+) and (-) symbols inside the
compartment.
Incorrect use of batteries can cause electrolyte leakage and will
corrode the compartment or cause the batteries to burst.
Therefore:
• Do not mix battery types, e.g. alkaline with carbon zinc.
Only use batteries of the same type for the set.
• When inserting new batteries, do not try to mix old batteries
with the new ones.
• Important! Remove the batteries if the set is not to be used
for a long time.
Batteries contain chemical substances, so they should be
disposed of properly
USING THE AC MAINS
7. Check if the mains voltage as shown on the type plate on
the base of the set, corresponds to your local mains voltage.
If it does not, consult your dealer or service organisation.
If your set is equipped with a voltage selector ®, adjust
the selector to correspond with your local mains voltage.
2. Connect the mains lead (packed inside the battery
compartment), to the MAINS socket and the wall socket. The
mains supply is now connected and ready for use.
3. To disconnect the set from the mains completely, remove the
plug from the wall socket.
O)
B
LU
GENERAL OPERATION
7. To select sound source adjust the CD TUNER TAPE/ off slider
2. Adjust the sound with the VOLUME and DBB (Dynamic Bass
Boost) controls
3. To switch off the set, adjust the slider to TAPE/ off position and
check that the cassette keys are released.
Note:
When the set is switched off the tuner presets will be retained in
the set's memory.