Philips AZ1020-17 - Manual (Page 6)

DIGITAL TUNER
MW (AM) TUNING STEP (SOME VERSIONS ONLY)
In North and South America the frequency step between adjacent
channels in the AM band is 10 KHz. In the rest of the world this
step is 9 KHz. Usually this frequency step has been preset in the
factory of your area.
To change the tuning step
7. Adjust the CD TUNER TAPE/ off slider to TAPE/ off position.
2. Press and hold down on BAND and SEARCH simultaneously
to select 9 KHz.
3. Adjust the CD TUNER TAPE/ off slider to TUNER position and
then release the BAND and SEARCH «■< controls
-'All preset stations will be lost and need to be programmed
again.
• To select 10 KHz, repeat steps 7-3 but use SEARCH instead.
TUNING TO RADIO STATIONS
7. Adjust the CD TUNER TAPE/ off slider to TUNER position
2. Press BAND to select your wave band
To tune to radio stations, press the SEARCH f « or control
until the frequency in the display starts running, then release
the control
- ' S r . c h appears in the display and the radio automatically
tunes to a station of sufficient reception.
3. Repeat if necessary until you find the desired station.
• To tune to a weak transmitter, briefly press SEARCH f « or
►w until you have found optimum reception or the correct
frequency.
—When STEREO appears in the display, you are receiving a FM-
stereo transmitter.
To improve radio reception
• For FM, pull out the telescopic aerial. Incline and turn the
aerial. Reduce its length if the signal is too strong (very close
to a transmitter).
• For MW (AM) and LW, the set is provided with a built-in
aerial so the telescopic aerial is not needed. Direct the aerial
by turning the whole set.
Ull.'lj;!
FM
c__
L
J l . 1 ^ 1 1