beautypg.com

Gasoline, Battery installation – Winco WL18000VE/N User Manual

Page 6

background image

3110-00

6

60706-39

* Below 40

O

F (4

O

C) the use of SAE30 will result in

hard starting.

** Above 80

O

F (7

O

C) the use of 10W-30 may cause

increased oil consumption. Check oil level more

frequently.

Briggs & Stratton recommends the use of their war-

ranty certified oils for best performance. Other high-

quality detergent oils are acceptable if classified for

service SF, SG, SH SJ or higher. Do not use special

additives.

GASOLINE

When using gasoline, always use fresh, clean,

unleaded fuel. This engine is certified to operate on

unleaded gasoline with a minimum octane rating of

87 or higher. Gasoline containing no more than 10%

ethanol is acceptable.

CAUTION: EQUIPMENT DAMAGE

Do not use unapproved gasolines, such as E15 or

E85.

Do not mix oil in the gasoline. Use of unap-

proved fuels will damage the engine components

and void the engine warranty.

Use of fuels with content of ethanol greater than

shown above may cause starting and/or perfor-

mance problems. Always insure that the fuel is

clean and free of all impurities.

WARNING: FIRE DANGER

Gasoline and its fumes are VERY explosive when

proper precautions are not taken.

Never use gasoline that has been stored for an ex-

tended period of time as the fuel will lose its volatile

properties and you will be left with varnish residue.

The varnish like substance will clog the carburetor

and will not burn properly.

The use of fuel additives, such as STA-BIL, or an

equivalent will minimize the formation of fuel gum

deposits. If a unit has been out of operation for an

extended period of time, it is best to drain old fuel

from the engine and replace with fresh fuel before

attempting to start.

See the engine manual for special instruction for

operating this unit at over 5000 feet

BATTERY INSTALLATION

These engine generator sets are shipped with a bat-

tery rack, and battery cables installed. A battery tie

down kit is shipped loose with each unit.

You will need to purchase and install a battery to op-

erate this engine generator set. A twelve volt battery,

group 6 rated at 500 CCA or larger is recommended

for this electric start engine generator set. Follow the

battery manufacturer’s recommendations for servic-

ing and charging prior to use. Connect the battery to

the electric start system using the cables provided.

CAUTION: EQUIPMENT DAMAGE

These electric start engines are NEGATIVE

GROUND. Use extreme caution when connecting

the battery. Connect the NEGATIVE battery terminal

to GROUND.

For your safety always connect the positive battery

cable to the “bat+” terminal first. Then connect the

negative battery cable to the “bat-” terminal. Make

sure all connections are clean and tight. Reverse the

sequence when disconnecting, disconnect the nega-

tive cable first. These engines produce enough direct

current to keep a battery charged under normal oper-

ating conditions, but were not intended to be used as

a battery charger.