Winco WT3000H/C - Manual (Page 12)

277-00
12
60706-24
TROUBLESHOOTING
PROBLEM (SYMPTOMS) POSSIBLE
CAUSES
———————————————————————
Won’t Start *Low Oil Level.
*Fouled spark plug.
*Out of fuel.
*Start switch in Off position.
*Fuel valve turn off.
*Plugged fuel filter.
———————————————————————
Voltage too low *Engine speed is too low.
*Generator overloaded.
*Defective stator.
*Defective rotor (field).
*Defective Capacitor.
———————————————————————
Circuit Breaker *Defective load.
Trips *Defective receptacle.
*Excessive Load.
———————————————————————
Voltage too high *Engine speed is too high.
———————————————————————
Generator *Overloaded.
overheating *Insufficient ventilation.
———————————————————————
No output voltage *Short in load (disconnect).
*Tripped or defective circuit
breaker.
*Broken or loose wire.
*Defective receptacle.
*No residual magnetism
(in generator).
*Defective stator.
*Defective rotor (field).
*Shorted capacitor.
*Shorted diodes on rotor.
*GFCI Receptacle tripped.
———————————————————————
SPECIFICATIONS
WT3000H/C
Generator manufacturer WINCO Inc
Part number 15041-07
Rotor resistance 0.87 Ohms
Stator resistance G1-N. 0.55 Ohms
Cap winding resistance 1.75 Ohms
Capacitor 40.0 mF
Capacitor part number 15051-000
Engine manufacturer HONDA
Engine model number GX160UT2
Type VA2 NH1
Spark plugs BPR6ES (NGK)
Air filter 17210-ZE1-822
Spark plug gap 0.00 in
Oil capacity .61 qts.