Wilson Audio Cub Series 2 User Manual

Page 55

A-1

R O U B L E

H O O T I N G

U I D E

ECTION

6.0 T

ROUBLESHOOTING

ETUP

DIFFICULTIES

Problem

Reason

One channel is not operating... Check inter-connects from source.

Check the connections on the speaker cables.

Both at ampliﬁer and speaker ends. Watch espe-

cially for connector touching each other.

Imaging is off center...

Check your connections. When a tweeter or mid-

range driver is not working, or is out of phase, the

imaging will be off. Double check your connec-

tions for red-to-red and black-to-black.

Play music at a low level, and listen to each driver

in each channel. You may have a driver that is

not operating correctly. If you ﬁnd a driver that is

silent please go to the “Driver Out section” of this

troubleshooting guide.

A chronic lack of bass energy...Check the input cable connections on your woofer

enclosure. If one channel is out of phase (con-

nections reversed), bass will be cancelled.

Note: Turn off your ampliﬁer, and unplug it from

the wall.

If you have found a driver that would not play,

move to the rear of this particular loudspeaker.

Driver not playing after

connections have been

veriﬁed.