Wilson Audio Cub Series 2 - Manual (Page 17)

C
ARE OF THE
F
INISH OF
Y
OUR
C
UBS
Your Cub loudspeaker enclosures are hand-painted with Wilsongloss ™ paint and
hand-polished to a high luster. While the paint seems quite dry to the touch, final curing
and complete hardening takes place over a period of several weeks. To protect the finish of
the Cubs during final manufacturing, shipment, and setup in your listening room, we have
applied a removable layer of protective film over the finish. We recommend that this film
be left in place until the speakers are in their final location in your listening room. Once
you have determined their final position, remove the film by peeling it off. Do not leave
this film on indefinitely, as it will leave impressions on the paint. It is important that the
delicate paint finish of the Cub be dusted carefully with the dust cloth, which has been pro-
vided. We recommend that the following procedure be observed when dusting the speakers:
• Blow off all loose dust
• Using the dust cloth as a brush, gently whisk
off any remaining loose dust
• Shake out the dust cloth
• Dust the finish, using linear motions in one direction parallel to
the floor. Avoid using circular or vertical motions.
Because the paint requires a period of several weeks to fully cure, we recommend
that no cleaning fluids such as glass cleaners be used during this initial period of time.
When the paint is fully cured, heavy finger prints and other minor smudges may be removed
with a glass cleaner. Always use the dust cloth. Stronger solvents are not recommended
under any circumstances. Consult your dealer for further information if required. Periodic
polishing may be desired over the years to maintain the high luster of the finish. We recom-
mend a nonabrasive carnauba-based wax and soft cloth.
2-1
C
A R E O F T H E
C
U B
L
O U D S P E A K E R