Wilson Audio Cub Series 2 User Manual

Page 42

4-6

U B

W N E R

A N U A L

Connection of the Cub to the Power Ampliﬁer

1. Turn off the power ampliﬁer(s) and remove the AC power cord from the wall
outlet.

2. Lay out the speaker cables before hooking them up to the CUBs. Make sure that
there are no kinks, twists, or right-angle bends in the cable. If you need to turn cor-
ners, attempt to use a gradual curve as opposed to a severe right-angle bend.

3. Connect the negative (normally Black) end of the speaker cable to the high cur-
rent speaker binding post with the engraved “-” above it ( see Figure 7).

Note: Do not over tighten the binding posts, overtightening can cause the posts to
break off.

4. Connect the positive (normally Red) end of the speaker cable to the high current
speaker binding post with the engraved “+” above it.

5. Plug your ampliﬁer(s) AC power cord into the wall outlet.

Note: Always attempt to keep your pair of speaker cables the same length. This will
ensure that the signals arrive at each speaker in the proper time frame, by traveling
the same distance to each speaker.