Vogelzang TR002B - Manual (Page 6)

Page 6 | SHILOH™ Vogelzang International Corp. TR002B | 20120125.0
Figure 6 – Attach Pedestal Top.
(Note– Position vent orifice towards front.)
Figure 5 – Insert Ash Drawer Support.
Figure 7 – Attach Pedestal to Stove Body
Figure 8 – Blower Option
Figure 9 – Attach Optional Blower to Stove Body
ASSEMBLY INSTRUCTIONS . . . continued
machine screws, lock washers and hex nuts. (See
Figure 6)
7. Place flattened carton/styrofoam packing material
on floor and carefully tip the stove body onto it’s
back.
8. Align four (4) corner mounting studs with holes
in pedestal top (Figure 7). Secure with four (4)
hex nuts.
11. For Optional Blower Assembly, note the position
of the blower opening in the rear of the stove.
12. Place blower gasket onto blower assembly (Figure
8) so as not to obstruct the air flow from the fan.
13. Mount the blower assembly to the back of the stove
(Figure 9) aligning the fan opening to the opening in
the back of the stove. Secure with four sheet metal
screws.
14. Route the power cord away from stove. Do not
allow the power cord to touch any hot surfaces.
Keep power cord at least 12˝ from stove surfaces.
15. Once stove is positioned, plug power cord into a
grounded 120v outlet.
16. After assembly, check to make sure fire brick are
properly positioned and ash cleanout cover is in
place.
9. Tip the stove assembly upright.
10. Set the ash drawer inside the open box formed by
the pedestal front and sides.