Vogelzang TR001B - Manual (Page 7)

TR001B | 20120125.0 www.vogelzang.com DEFENDER™ | Page 7
LOCATING STOVE
your local building codes or fire protection
ordinances.
NOTICE: Any wall containing combustible
materials such as wooden studs, drywall and
faced with brick or stone MUST be considered
a combustible surface.
7. DO NOT install this stove in a mobile home,
manufactured home, trailer or tent – NO
EXCEPTIONS! (HUD Federal Standard:
24 CFR Ch.xx)
8. The clearances provided are minimum dimensions
set by UL 1482-2010 & ULC S627-00, tested
and applied by OMNI Test Laboratories, Inc., the
manufacturer’s testing laboratory. Installation of this
stove must comply with the latest edition of NFPA
211 (US)/CAN/CSA-B365 (CDN) for reduced clear-
ances and/or your local building code rulings. Use
whichever minimum dimensions are the LARGEST.
Clearances listed and shown MUST be adhered to
for safe operation of this appliance. CLEARANCES
MAY NOT BE REDUCED BY ANY MEANS IN USA
OR CANADA.
9. NEVER OPERATE THIS STOVE WITHOUT THE
ASH CLEANOUT DOOR OR WITH THE ASH
DRAWER REMOVED – very dangerous operating
conditions could result.
Failure to follow these minimum clearance require-
ments may result in an unsafe installation and could
cause a fire.
10. This stove meets U.S. Test Standard: UL 1482-2010
& Canadian Standard: ULC-S627-00.
11. Always locate stove to provide a source of fresh
air into the room where the unit is installed.
Failure to do so may result in air starvation of other
fuel burning appliances and the possible develop-
ment of hazardous conditions.
Continued on next page
12"/30.5cm
12"/
30.5cm
CORNER CLEARANCES
Fig. 7 – Top View
Minimum Corner Clearances
from Combustible Surfaces
CAUTION: REPLACE FIREBRICKS BEFORE
FIRING WOODSTOVE. POSITION FIREBRICKS
SO NO GAPS REMAIN BETWEEN BRICKS.
CAUTION: KEEP FURNISHINGS AND
OTHER COMBUSTIBLE MATERIALS AWAY
FROM THE STOVE AND OUTSIDE MINIMUM
CLEARANCES.