Viconics H100 - Manual (Page 2)

2
TABLE 2: TRANSMITTER ACCESSORIES
H50 Internal humidity sensor for H100 transmitter and for H80 remote wall sensor.
H60 Duct humidity sensor to mount directly onto the back of any H100 transmitter.
H71 Duct humidity sensor to mount directly onto the supply or return of the ventilation duct.
H80 Wall humidity sensor to mount in any remote location.
008-0089 Replacement lexan (cover sticker) for H100 transmitter
024-0048 Transmitter replacement base with connector (H50 internal humidity sensor not included).
H50 INTERNAL SENSOR H60 DUCT SENSOR
This humidity sensor can be
mounted directly on 024-0048
transmitter base. This humidity sensor can be
mounted directly onto the back of
any H100 transmitter, with the
supplied hardware. This
transforms the transmitter into a
duct-mounted transmitter.
WARNING:
Where failure or malfunction of
H100 series transmitters could
lead to an abnormal operating
condition that could cause
personal injury or damage to the
equipment or other property,
other devices (limit or safety
controls) or systems (alarm or
supervisory) intended to warn of,
or protect against, failure or
malfunction of H100 transmitters
must be incorporated into and
maintained as part of the control
system.
H71 REMOTE DUCT SENSOR H80 REMOTE WALL SENSOR
LOCATION OF CALIBRATION
POTENTIOMETER
This humidity sensor can be
mounted directly onto the supply
or return of the ventilation duct.
The H100 may be located on the
wall with humidity sensing from
the remote H71 sensor location. This humidity sensor can be wall
mounted in any remote location.
The transmitter may be located
on the duct or other location, with
humidity sensing from the H80
sensor location.