Viconics SED-WDS-P (ZigBee Pro) Door and Window Sensor Installation guide - Manual (Page 2)

Door/Window Sensor Installation Guide
2
© 2
01
4 V
ic
on
ic
s. A
ll r
ig
ht
s r
es
er
ve
d.
Viconics Technologies Inc. | 9245 Langelier Blvd. | St.-Leonard | Quebec | Canada | H1P 3K9 | Tel: (514) 321-5660 | Fax: (514) 321-4150
028-6076-00 www.viconics.com | [email protected] October 2014
INSTALLATION
This procedure shows you how to install a Door/Window Sensor.
Complete the following steps to correctly install the Door/Window Sensor:
1. Install battery.
NOTE: ensure battery polarity is correct.
NOTE: When batteries are first installed, the sensor automatically goes into pairing mode. Refer to the
Room Controller pairing procedure for commissioning.
2. Pull plastic tab
3. Install Sensor Housing.
4. Install Magnet.
5. Install Sensor.
Location
Always consider the following location constraints before installing Door/Window Sensor:
1. Do not install in areas with direct heat source.
2. Do not install near any air discharge grill.
3. Do not install in areas exposed to direct sunlight.
4. Ensure Sensor has sufficient air circulation.
5. Ensure ceiling surface is flat and clean.
Sensor Placement and Orientation
Ensure Door/Window Sensor and Magnet face each other as shown in below illustration. The Magnet and Sensor
can be a maximum of 0.75in (1.9cm) apart. If aligned properly, you will hear a ‘click’ when they approach.
The below shows you how to correctly align the Door/Window Sensor.
Correct Alignment Incorrect Alignment