Tamino – Verity Audio Tamino - Packing / Unpacking Instructions User Manual

Page 2

1005 Saint-Jean-Baptiste, Suite 150
Quebec, QC G2E 5L1 Canada

Tel: (418) 682-9940

Fax: (418) 682-8644

www.verityaudio.com

[email protected]

2004.06.30

Tamino

P r o d u c t P a c k i n g I n s t r u c t i o n s

The packaging accessories are:

(2) 14" x 17" x 18" cardboard boxes;

ii. (2) Inner cardboard boxes;
iii. (2) Accessory

boxes;

iv. (4) Protective wooden boards;
v.

(2) Top / bottom protective foam covers;

vi. (2) Speaker grilles;
vii. (1) Package containing the owner’s manual

and registration card.

The Tamino loudspeakers are packed in cardboard boxes and
provides space for:

(2) Tamino loudspeakers;

ii. (2) Speaker grilles;
iii. (4) Accessory boxes.

Each accessory box contains:

(2) Connector

posts;

ii. (4) Threaded spikes;
iii. (4) Threaded spike locking nuts.

1. Turn off the power amplifier(s);

2. Completely unscrew the four connector posts from the

Tamino loudspeakers and disconnect the speaker cables;

3. Remove all the threaded spikes and locking nuts from the

loudspeaker cones;

4. Store two connector nuts, four threaded spikes and four

locking nuts in each plastic case.

5. Wrap the Tamino loudspeakes in their plastic bags;

6. Lift a Tamino and insert it into the bottom foam cover,

then put the top foam cover on the loudspeaker;

7. Cover the speaker with the inner cardboard box;

8. Strap the outside of the inner cardboard box in order to

hold together the bottom foam cover, the inner cardboard
box, and the top foam cover;

9. Open the main cardboard and place it in its vertical

position. Follow the directions printed on the main
cardboard box;

10. Gently slide the inner cardboard box inside the main

cardboard box, the front of the loudspeaker facing the
opening;

11. Carefully lay the main cardboard box on its horizontal

position;

12. Place the four protective wooden boards inside the main

cardboard. One on each side and one on each extremity;

13. Slide one grille between the top foam cover and the main

cardboard. The grille’s studs should be pointing towards
the speaker and plunged inside the foam;

14. Slide the owner’s manual between the wooden board and

the main cardboard box;

15. Repeat steps 6 to 13 for the second Tamino;

16. Close the cover of both boxes and tape them adequately;

17. Strap both boxes;

18. The Taminos are ready to be addressed and shipped.