Verity Audio Lohengrin IIS - Packing / Unpacking Instructions for Woofer - Manual

1005 Saint-Jean-Baptiste, Suite 150
Quebec, QC G2E 5L1 Canada
Tel: (418) 682-9940
Fax: (418) 682-8644
www.verityaudio.com
[email protected]
2004.06.30
Sarastro
Lower Module Packing Instructions
The packing accessories are:
i. (2) ATA approved flight cases;
ii. (2) Fabric covers;
iii. (2) Speaker grilles;
iv. (1) Package containing the owner’s manual;
v. (2) Accessory boxes.
Each flight case provides space for:
i. (1) Lower module cabinet;
ii. (1) Speaker grille;
iii. (1) Owner’s manual and registration card
(contained in one case only);
iv. (4) Teflon skates
v. (1) Accessory box.
One accessory box provides space for:
i. (12) Connector posts.
The other accessory box provides space for:
i. (8) Threaded spikes;
ii. (8) Threaded spike locking nuts;
iii. (4) Jumper cables.
WARNING: The Sarastro’s lower module and its packaging are
big and heavy. Any operations that ask for moving, lifting or
tilting will require the assistance of a second person.
Attempting to do it alone could be hazardous, create injuries
or permanent damage to the loudspeaker.
1. Unscrew and remove the four connector posts from the
lower module;
2. Slightly tilt the lower module to one side and hold it
while the other person removes the spikes. Repeat for the
other side;
3. Cover the lower module with the protective fabric bag.
The bottom elastic band should surround each cone.
4. Open and remove the flight case upper shell. Bring the
bottom of the flight case next to the lower module
cabinet. Align it to fit with the bottom of the cabinet.
Make sure to match with the serial number indicated on
the flight case;
5. Place the connector posts, the threaded spikes and locking
nuts in the accessory boxes and store them in the space
provided in the bottom of the flight case;
6. Attache the monitor’s front grilles inside the upper shell;
7. Lift one module and carefully install it inside the flight
case;
8. Carefully install the flight case upper shell by matching
the two black pop rivets together;
9. Secure the flight case upper shell in place by closing the
four latches. Locking the latches with tie wraps is highly
recommended;
10. Repeat step 1 to 9 to pack the second loudspeaker;
11. The Sarastro’s lower modules are now ready to be
addressed and shipped.