VACUUBRAND MV 10C NT VARIO o.C. - Manual (Page 39)

page 39 of 97
Electrical connection
Emission condenser Peltronic:
Plug in the power cord.
• Check the power source and the Peltronic’s rating
plate to be sure that the power source and the equip-
ment match in voltage, phase, and frequency.
Connect the emission condenser Peltronic via the
VACUU•BUS cable to the CVC 3000 controller.
Switch the emission condenser Peltronic on.
Plug in the power cord.
• Check the power source and the pump’s
rating plate to be sure that the power source
and the equipment match in voltage, phase,
and frequency.
Switch the pump on.
To operate the pump / the pumping unit, a CVC
3000 or VNC 2 VARIO VACUUBRAND controller
is required! Connect the controller to the VACUU•BUS
cable of the NT VARIO pump. Switch the controller on.
O ➨ I