Twin Eagles TESG-24N - Manual (Page 5)

GAS REQUIREMENTS
– Salamangrill
Each Salamangrill is set and tested at the factory for the type of gas supply intended to be used.
Identify the type of gas on the rating plate located at the rear of the unit. It should either be Natural Gas
(NG) or Propane/Liquefied Petroleum (LP) gas. Use only the gas stated on the rating plate. A gas
conversion kit is available for the Salamangrill
(LP-to-NG/ NG-to-LP) with instructions on how to do it.
 PROPANE/ LIQUEFIED PETROLEUM
(LP)
If your Salamangrill is factory built for LP, the regulator supplied is set for 10” water column and is
only to be used on an LP gas cylinder (5 gallon 20 lb.) along with the supplied gas hose.
 Safety Requirement for LP Cylinder; NEVER USE A RUSTY or DENTED LP CYLINDER
or A CYLINDER WITH A DAMAGED VALVE. The LP-gas supply cylinder must be
constructed and marked in accordance with the Specifications for LP-gas Cylinders of the U.S.
Department of Transportation (D.O.T.) or the National Standards of Canada CAN/CSA-B339,
Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods, and Commission.
 Safety Requirement f or LP Plumbed-In; the installation must conform to all local codes and
CAN/CGA-B149.2, Propane Installation Code.
 NATURAL GAS
(NG)
If your Salamangrill is factory built for natural gas, the regulator supplied is set for 4” water column
and can be verified by removing the brass hex cap. You will find the conversion plastic pin attached to the
cap to the underside of the cap. If the disc (1/2 in. diameter) of the pin is close to the cap, then the regulator
is set for natural gas. If the disc is at the tip of the pin, away from the brass cap, the regulator is set for
system LP application.
 Safety Requirement for NG; The installation must conform with local codes or, in the absence of
local codes, with either the national Fuel Gas Code, ANSI Z223.1/NFPA 54, or CAN/CGA-B149.1,
Natural Gas Installation Code.
4
NEED ASSISTANCE? PLEASE CALL:
(800) 789-2206