Ii. run wire harness, Iv. test the enclosure, V. attach the enclosure to the vehicle – Clarion PSWDRAM User Manual

Page 4: Vi. reassemble the vehicle, Iii. attach brackets to enclosure, Regular cab instructions

Clarion Corporation of America

661 West Redondo Beach Blvd Gardena, CA 90247

800-Go-Clarion

10 - PSWDRAM Rev. 1 (04/00

)

II.

RUN WIRE HARNESS

A. Run harness to the storage tray in the rear of the vehicle behind the passenger seat.

A. Place enclosure upright so that the rippled surface is down.

B. Position brackets so that the vertical slots line up with the verti-

cal set of dimples on the enclosure.

C. Attached brackets with the supplied pilot point Phillips screws,

screwing through the locating dimples on the enclosure (the
dimples should be centered in the vertical slots on the bracket).

IV.

TEST THE ENCLOSURE

A. Place enclosure into the vehicle, the subwoofer will fire down (the correct position of the enclosure is underneath the rear folding

seat on the drivers side).

B. Plug in the wire harness to the enclosure (ground the 8" black wire on the wire harness).

C. Plug in the “T” harness behind the radio (or hard wire the supplied “pigtail” harness to the factory wiring).

D. Test for proper operation.

E. Adjust subwoofer gain (gain pod is located on the amplifier next to the wire harness connector, and is adjustable with a Phillips

screw driver).

Regular Cab Instructions:

ATTACH THE ENCLOSURE TO THE VEHICLE

A. Screw in the brackets to the back of the storage tray using the

supplied 1" self-taping screws (2 screws per bracket).

VI. REASSEMBLE THE VEHICLE

A. Make sure all the wires are hidden. Then do the process in reverse order.

III.

ATTACH BRACKETS TO ENCLOSURE