TruTrak Sorcerer – Outdated - Manual (Page 11)

10
altitude select screen the
display will show the
following screen. To set the
barometer see Barometer set
on page 8.
If the barometer set has
been done the display will show
the following screen.
NOTE: If there is not a
GPS signal present, the
[VNAV]
button will not
function.
At this screen the SEL ALT
numerals are under lined so that
rotation of the encoder selects
the target altitude. When this is
done press enter.
Once the desired altitude
has been entered the DIST
numerals are underlined so that
rotation of the encoder now will
select the distance, in nautical
miles, in which the selected
altitude will be reached. Click
the knob to enter the distance
and begin the transition to the
selected altitude. The autopilot
will now revert to the normal
flight display.
As in the altitude select
mode, the selected altitude and
selected distance can be
adjusted by clicking the knob to
move the cursor first to the
selected altitude, then to the
selected distance. A third click
will click will return the cursor
to direction, or after a short
period of time the cursor will
return automatically to
direction.
Minimum Airspeed
Any time the autopilot is
engaged, and the airspeed falls
to the minimum airspeed
setting, the autopilot will begin
to flash
MIN AS , as shown
below.
Maximum Airspeed
Any time the autopilot is
engaged, and the airspeed
reaches the maximum airspeed
setting, the autopilot will begin
to flash
MAX AS , as shown
below.
Stopping the
Transition to a
Selected Altitude
Once the aircraft is in
climb or descent to a selected
altitude, the process can only be
stopped
by entering the
ALT HOLD mode. This is
accomplished by arriving at the
selected altitude or by selecting
the
ALT HOLD mode by
clicking the [ALT] button.