Triner Scale TS-PFS Users Guide - Manual (Page 5)

13
Triner Scale TS-PFS User’s Guide
4
DIGITAL DISPLAY ICONS & ANNUNCIATORS
The status icons and annunciator arrows inform the user
of the scale’s status, the mode of operation, and the type
of information being displayed in the digital readout.
Low Battery Status Icon ( )
Flashes to indicate the battery power is low.
After approximately 40 hours of continuous battery-
powered operation, the low battery icon will flash for 25
minutes, then rapidly flash for 5 minutes before the scale
powers off.
Refer to “Reserve Power Feature” in this manual for
additional information.
Center of Zero Status Icon ( 0 )
Displays when the scale is on Zero.
Indicates there is no weight being registered in the scale’s
electronics.
Stable Status Icon ( )
Displays when the scale is Stable.
Indicates the scale is not fluctuating or drifting.
Annunciator Arrows ( )
• Indicate the operating mode
• Indicate what type information is being displayed in the
digital readout.
Refer to “Operating Modes” in this manual for additional
information.
Triner Scale TS-PFS User’s Guide
GENERAL OPERATION, cont’d
Holding a Weight
To hold a weight of an item on the weighing platform, press the
HOLD key. The displayed weight will continually flash, showing
that the weight is being held.
The only function available in hold mode is the ADD key function.
To return the scale to normal operation, press the HOLD key
again.
Resetting the Scale’s Memory
- Press and hold the RESET key until “reset” displays.
- “No” will then display, to prevent accidental erasing of the
memory
- Press the right arrow key (ADD/ON) to change the display
to “YES”
- Press the SET key (HOLD-RUN/UNDO) to clear the scale’s
memory
Note : To avoid resetting the memory, press the SET key when
“no” displays.
Subtracting/Backing Out a Weight
While in Auto Add Mode 1 or Auto Add Mode 2, press the
SUBTRACT key.
Dashes will display to left of the indicated weight, showing that
the scale is in Subtract Mode.
The next item placed on the scale platform will be subtracted
from the cummulative totals for weight and item count.
The scale then returns to normal operation.
Zeroing the Scale
Occasionally, certain conditions can result in the scale not being
on the center of zero when at rest. This condition is indicated
by the center of zero icon not displaying in the readout.
To remedy, remove all items from the weighing platform, and
press the ZERO key. Note that the center of zero icon will
display, indicating that the scale is on center of zero.
0
Low Batt.
Zero
Stable AUTO
ADD
MANL
ADD
TOTAL
WT
ITEM
WT
ITEM
COUNT
Status Icons Annunciator Arrows
Fig. 1