Installation instructions for grab bars, Installation instructions for shower seats con’t – Trending Accessibility Multi-Piece (4836, 6033, 6036, 6048, 6060) User Manual
Page 13
13
5.- Using a power drill with a 0.120 diameter drill through the wall the three (3) mounting
holes for each flange.
Recommended tools for installation:
THIS COMPLETES THE INSTALLATION OF THE SEAT
7.- Place the seat against the mounting wall with each hinge aligned to the mounting holes.
Utilizing the six (6) #10 x 2” Stainless Steel screws, place a Phillips screw driver into
your power drill and securely tighten each of the six (6) screws.
1/4” Power Drill
#2 Phillips Screw Driver and/or Phillips drill insert
1/2” Open end wrench or a small Crescent wrench
1/8” Diameter drill bit
Tape measure
Pencil/pen
Silicone Caulk
INSTALLATION INSTRUCTIONS FOR SHOWER SEATS Con’t:
1.- Select the particular size and style of grab bar you want to install. Certain grab bars
have snap in place flange covers, and others have exposed flanges.
2.- For grab bars with snap in place flange covers, use the handle of a Phillips screw
driver to tap back the covers on the bottom edge of the covers. It will be convenient in
the installation process if the covers are tapped together in the center of the grab bar.
3.- Determine the position you want the to install the bar. Place the bar against the wall.
Using a pencil, mark the location of each mounting hole at both ends of the bar.
4.- Using a power drill with a 1/8” diameter drill bit, drill, each mounting hole at a depth of
approximately one (1) inch.
Recommended tools for installation:
THIS COMPLETES THE INSTALLATION OF THE GRAB BAR
6.- Take two (2) of the #10 x 2” Stainless Steel screws. By hand, start one mounting screw
in each end of the bar into the wall.
7.- Use a power drill with a Phillips drill bit to fully install these mounting screws.
8.- Take the remaining #10 x 2” screws and place them into the remaining open holes.
Use care to snug up the screws, but to not over-torque that the screws strip out the
factory installed backer board.
9.- If installing a bar with snap-on covers, move the covers into place at each flange.
Twist the covers clockwise or counter clockwise to tighten the covers onto the flanges.
1/4” Power Drill
#2 Phillips Screw Driver and/or Phillips drill insert
1/8” drill bit
Tape measure
Pencil/pen
Silicone Caulk
INSTALLATION INSTRUCTIONS FOR GRAB BARS
5.- Apply silicone caulking around and inside each drilled hole before installing the grab bar.
6.- Apply silicone caulking around and inside each drilled hole before installing the seat.